Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have two switches 6500 sup2/msfc2, IOS Version 12.1(22)E. Hsrp, OSPF are configured. When I connect a sniffer on a port, I see the traffic of others clients as if the span is configured. It is a known bug ?
Hi,I authenticate a Windows XP machine through a 3550 switch with a radius Windows 2003 with 802.1X EAP.The authentication of the machine is oK, the swith applies the attributes to the 802.1X port : a vlan ID and a Per-User acl.When the Per-User acl...
Hi,I've a 3550 with an Ias 2003 and a Windows XP.On the same PC, authentication PEAP is ok with the first user, when i do a new authenticiation with an other user, the informations used for the authentication are the informations of the first user....
hello,It's possible to tag route with ospf, without use a redistribtion with an other protocol, whithout use reditribut connected and static route.Thank you very much.
Thank you for your reponses, the description of unicatflooding in the tech tip resembles so that I meet on my 6500. I will take the advice of the tech tip, to try to limit these unicastflooding
Sorry I sent the precedent message too quickly, I found the solution. It's simply because on an Layer 2 interface on a 3550 with the "swithport" command, you can applie an outbound Acl.
I had the same problem with the IAS 2003 wizard.The RAS Policies was "NAS Port= Ethernet", but my swith 3550 sent NAS port= Async. I could see that with a sniffer in the values for RADIUS Attribute 61 (rfc 2865), the value for Ethernet is 15 and for...
