Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
in EVE-NG I simulated a simple network environment with an FMC (6.4.0-113) and two FTD in cluster (6.4.0-102). I also added two PCs in order to test the security policies and the traffic works as I expected: I created this LAB in order to replicate a...
Hi guys,it's my first time with the route leaking feature and I tried to configure it on my LAB via EVE-NG, but unfortunately it didn't work. I attached a screenshot about my LAB.my little enterprise network has been subdivided in three different vrf...
I want to see the sessions table from a PIX with Software Version 8.0(4). following one session seen using the "show conn" command (the IP addresses have been changed for security reasons):
134 in use, 3212 most usedTCP outside s10.102.128.89:8080 ...
Hi security experts
I configured a client-based SSL VPN lab throught the GNS3. this is my network topology:
USER-PC is a vmware virtual machine. It uses the vmnet30 interface to work. with the vmnet30 interface I can choose two of my virtual m...
what is Hash-based Message Authentication Code (HMAC)? how does it works? what is the different between the HMAC and a hash algorithm?
during the IKE phase 2 tunnel negotiation (I'm talnking about the IPsec protocol) both the vpn peers must agree ...
- both ASAv have nat that does a dynamic translation on any traffic from inside to outside. I would think you would want to configure so that VPN traffic is not translated.
that NAT policy allows the internet traffic from inside to outside, but for...
I changed a little bit my topology. I replaced my vsrx-milan with an ASAv firewall. currently my main goal is to see the IPsec tunnel works between the two ASA firewalls. I configured both, but the VTI interface is still in down state:
for me it...
i think it's not an IPsec problem. if i create a tunnel interface on a router, his interface status goes up immediately. in my ASAv firewall instead, the tunnel interface status stays down even after i created it. it's not a good behaviour..
