Can you tell what ACL did you setup at Phase 2,
And also check the Security Association with show crypto ipsec sa and check the you have both Security Inbound and Outbound with ESP established.
You may also send your ASA config to see if w...
No, the ASA does not support PBR.
But Check this by Kureli Sankar
PBR on the router outside the firewall
With this method we can configure both the ISP links on the router outside the firewall. We can translate some traffic to use Primary ISP pr...
Hi,I smell a Layer 2 problem with this config and specially with VLANS.I can see that your Inside Interface is linked to VLAN 1 (The Default), if that is the case then you need to mark VLAN 1 as Tagged in your Trunk (1 or 2).Good luck