Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am not able to route traffic fully through the tunnel. It is up and I can ping across to the other side of the tunnel. I can also jump on a host in Non-Prod VPC 1, DCS VPC, Prod VPC(example host from Non-Prod-10.16.22.100) and ping the CSR on the o...
I am not able to route traffic fully through the tunnel. It is up and I can ping across to the other side of the tunnel. I can also jump on a host in Non-Prod VPC 1, DCS VPC, Prod VPC(example host from Non-Prod-10.16.22.100) and ping the CSR on the o...
Can someone assist in setting up remote access for home lab? I have 5505 asa I can use. I have 4 switches connect to server. Server connects to my home router which connects to service provider router. Where would I place the asa and what configurati...
Hello All,
I am hoping someone can answer this for me. perform two factor authentication using radius nps with one being username/PW and the other being certificate authentication. Is this possible with NPS if so how would I implement it?
If Radiu...
Hello All,I was hoping someone would be able to let me know if it is possible and if so how do I go about implementing a two factor authentication on Radius server NPS? The two forms of authentication I want to use is UN and PW, and Certificates.If...
I have csr1000v on esx host. On optiplex then 4 switches connect to optiplex. You say put vsphere on internal PC so I get access server. Then put teamviewer on that PC so I can reach it remotely from other laptop right? If correct doesn't teamviewer ...
Thank you for reply! The laptop I have is the one I travel with. I can see if I can get other one. Would teamviewer create lag when jumping from internal PC? I don't want my studies to be painful cause slowness
