Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I have an L3 switch with ospf connected to two DNS servers. Each DNS server propagates an IP listener by OSPF.
I understand, that OSPF having routes of equal cost, should balance the load by default, but this is not happening. So, how do I confi...
Hi. I have a confusion regarding the size of MTU.
What happens in a router with the packets if through the input interface it receives 1500 MTU but through the output interface it has two routes (OSPF equal cost) with 1400 MTU each ??
Fragment the pa...
Hi.
I have an ASA 5508-x connected to two ISPs. I made the relevant configurations of the static route with superior metric of SLA monitor, Track ID and the IP tracking address 8.8.8.8.
When I did the backup tests of ISPs, they worked fine by disconn...
Hi.
It is technically feasible to use 2 ISDN links from the same provider on a card with 1 E1 port.???? That is, having two trunks on an E1 card with an E1 port.
If feasible, how do I set dial-peers to route the call?
Thank you.
Hi.Thanks for your answer.perform the test of the command, and it is shown that it divides into traffic:SW1 # sh ip cef exact-route 60.60.60.10 210.0.0.4 60.60.60.10 -> 210.0.0.4: Vlan30 (next hop 30.0.0.2)SW1 # sh ip cef exact-route 60.60....
Thanks for your reply.
So,
if by the input interface the MTU is maintained at 1500. Then, the same two output interfaces are configured with MTU from 1400 to 3000 (for example);
- the received packet of 1500 MTU an interface of 3000 MTU will be sen...
