Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Consider the following setup
2x 5k as part of a VPC setup a FEX switch which is connected with vpc portchannel with 1 uplink to each Nexus
If like in the picture, 1 of the 2 uplinks goes down. Does the remaining up port act like an orphan port?
...
Hi,
I am adding VPC to a nexus deployment this weekend,unfortunately some new 2k switches haven't arrived so I will not be able to create a FEX , portchannel etc for the equipment on the other floor of the data centre.
So I'm stuck with two stan...
When you call an action cli in EEM , the output generated from the last cli command is stored in the variable $_cli_result, the issue is this is overwritten each time action cli is written.
So if I have two cli commands I want the output for ( i've...
Hi
We've a stack of 4 3850 switches trunked to catalyst 6500. The switches are connected to ESX servers. We are getting the following log messages
*May 19 12:21:14.300: %IPC-5-WATERMARK: 8210 messages pending in xmt for the port (10900C00.4) f...
Hi all,
I've the following problem which I hope people can help me with. I've built a lab as proof of concept.
The topology is attached.
> There are 4 sites, each site is connected via two separate VPLS networks. The aim is that as long as there i...
Hi Mark,
Thanks for clarifying and I appreciate your suggestion. I was hoping I'd be able to do that, but as these are standalone switches and running cables is not an option.I will have to keep to the original design which will involve STP blocking...
Hi Mark,
Thanks for your response,
Just so I know I'm understanding your suggestion correctly would it be possible for you to elaborate a bit more regarding please. Am I correct in thinking you mean
1) Create two po's (one for each switch and keep ...
Hi Chandan, Yes, these messages are continuous, I do not know how long they have been appearing as these switches are not pointing at a syslog server at the moment. I am running SW Version : 03.02.02.SE SW Image : cat3k_caa-universalk9ThanksC...
