Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have three HA pairs of 5508s and one standalone 5508 that have all of a sudden started rebooting every few days. All are on 8.3.143.0 and have been for over a year with no major changes. It seems like there is something triggering the reloads, bec...
Hello All, I'm looking for some suggestions on a new network design. We have two data centers (directly connected) and many remote sites (DMVPN), all running OSPF. We are looking at adding both MPLS and SD-WAN solutions to replace DMVPN. These servic...
Has anything changed recently with the way APs react to changing HA Primary/Secondary/Tertiary controllers? Previously I was running 7.6.100.0, and when I would make changes to AP HA settings (either on the WLC or Prime), the APs would move and join ...
We have AnyConnect On-Demand implemented for iPhones/iPads. It works good when needed, however we also notice that it connects on it's own from time to time, with no apparent request for VPN services. We have included/excluded domains setup. Does any...
Unfortunately our SmartNet on the 5508s just expired, We're in the process of migrating off since they are EOL, and the renewal was too expensive to justify. Of course as luck would have it, as soon as Smartnet expires we start having these issues. T...
@Daps wrote:Solved. There is a file named "auto-s". deleted the file. Copy the new image. Select boot new-image ...and done This. Per Cisco, there is a script that runs on the leafs, and if the bootflash is too full, it will just start deleting file...
I havent' been able to get my lab back online to try this, but I did at one point have a 'match' statement with a prefix-list of 0.0.0.0/0, and it did not help, so I just took it back off (route-map permit without a match statement should match all r...
We recently did something similar..
1. Most the guides or docs I have seen suggest a separate L3 link between the two 9Ks. Your diagram doesn't have that, but the document you referenced does (they have 'L3 Link' in place of your 'Keepalive). This...
