Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys, I hope everyone is well... Im writing today looking for help on a wireless topic. I got a pair of 3702i Aps and I load a standalone image on them (ap3g2-k9w7-mx.153-3.JPL). Im trying to get the best throughtput on the 5Ghz radio, I know t...
Hello everyone,I been working on an issue I have on the wireless Network, the APs are dropping from the WLC and im trying to get some ideas from the logs. I changed the APs from Local to FlexConnect but the result was the same, after certain time the...
Hello guys, Im dont know much about APs and I would like to know if the all APs from Cisco can work as Autonomous? the models:AIR-CAP3702 ?AIR-CAP3802 ?AIR-CAP2602 ?AIR-CAP2702 ?etc... Thank you!!! have a good day...
Hello All,
Im new with all the QoS settings and I need some help. I the following simple topology:
LAN (int Vlan4 10.0.0.0/24)--------------- Router c861W-------------WAN (public IP by dhcp 200.75.56.X/24)
In the LAN I have 4 users with Manual DHCP a...
Hello All,Here is a simple question...Its possible to link a WLC2100 running release 7.0.250.0 and a AP Cisco OEAP 600 Series? It looks like is possible but I would like to confirm if someone had try this before... thank you. Dan
Hi There, Im testing with Laptops, and iPhones and Android devices. I found that my APs to have a better throughput need to be power on with poe+ they are using now 16.8W (Power drawn: 16.800 Watts) that helps to get the Speed I was looking for, also...
Thank you for the heads up, I did some more testing and I was conecting the AP using 802.11af instead of 802.11at now the APs are using 16.8W each and the 4x4 is working fully. however I still getting 200Mbps on both directions and the switch is Giga...
Im trying to get the max throughtput using the interface Dot11Radio1 on 5Ghz, Im dont think I would be able to get the max throughtput using the 2.4Ghz radio, I continue testing if I can get better results I will let you know, Thanks
Hi There, I currently have 500Mbps bandwidth however the AP with the config I just mention before can get around 200Mbps but its only showing a 40Mhz channel not really an 80Mhz on the config I see 80Mhz but using and analyzer I see only 40Mhz. Also ...
Hello Guys, I have a quick question, what is the difference between a regular AIR-AP3702I-A-K9 and a AIR-AP3702I-UX-K9 AP?I dont understand if the AIR-AP3702I-UX-K9 model can support autonomous mode as the AIR-AP3702I-A-K9. Im not sure whats the diff...
