Link a WLC2100 and access point Cisco OEAP 600 Series

[danielnigrinis]

Hello All,

Here is a simple question...

Its possible to link a WLC2100 running release 7.0.250.0 and a AP Cisco OEAP 600 Series? It looks like is possible but I would like to confirm if someone had try this before... thank you.

Dan

[Sebastian Helmer]

The OEAP was introduced in  7.0.116.0. The concept is to add it via NAT IP to the "external" side of an WLC. I would say, if u have the NAT option on your AP-Manager interface/Manager interface it should work. Give it a try...

Best regards,

Sebastian

pls. rate if helfpful

[George Stefanick]

the 2500 supports OE .. Here is the 2500 data sheet. 

http://www.cisco.com/c/en/us/products/collateral/wireless/2500-series-wireless-controllers/data_sheet_c78-645111.pdf

Here is a link for everything Ap600

http://www.cisco.com/c/en/us/support/wireless/aironet-602-officeextend-access-point/model.html

Here is a link to the config guide 

• The first controller release that supports Cisco Aironet 600 Series OEAP is 7.0.116.0

• http://www.cisco.com/c/en/us/support/docs/wireless/aironet-600-series-officeextend-access-point/113003-office-extend-config-00.html