Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a Cisco Router at our head office and some draytek routers at our branch offices. I've created a Site to Site VPN tunnel which works fine to a degree.The Tunnel is up and traffic can pass over the tunnel.All the clients are configured t...
Hi All, I've configured NAT on a Cisco 1921 router. I've configured port 25 to be forwarded to a mail server however, when I connect a site using a site to site IPsec vpn everything works besides the ports that I have NAT'd in. ip nat pool WIGAN 22.2...
Hi, I have a Site to Site VPN setup and the connection appears to be UP. But i am unable to ping in both directions? I am unable also to ping the internal interface of the routers. Here are the configs:MAIN OFFICE:Current configuration : 5127 bytes!!...
Hi, I have a Static NAT rule to allow ports 443 and 3389 in from public address for RDS enviroment.I'm able make a connection from the outside to inside but if i was to request the connection from inside to outside and back in, i get a page cannot be...
Hi All, I've configured a site to site VPN between two Cisco 1921 routers. One router on the Remote Site is a VPN/Nat on a Stick. However the VPN is showing up-Active but i can't transmit any data across it.I think it may have something to do with t...
Hi Colin,
Thanks for the reply,
So to confirm if i amend the following line:
ip nat inside source static tcp 192.168.1.241 25 22.22.22.157 25 extendable
to
ip nat inside source static tcp 192.168.1.241 25 22.22.22.157 25 route-map nonat
and then add ...
So i just took the following line off the branch office router.ip access-list extended VPN-TRAFFIC permit ip 10.10.10.0 0.0.0.255 192.168.1.0 0.0.0.255and the ping stopped on the main office router. Therefore i'm assuming it's something wrong with th...
Yes the VPN is UP-ACTIVEI agree i think this is an ACL list issue, but i've not configured then before.Here is the logs again.Main Officecrypto isakmp policy 1 encr 3des hash md5 authentication pre-share group 2crypto isakmp key Pa$$w0rd address 222....
