Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day everyone,we have observed a very strange behavior. on one of our C9300 Switches, even though that AppGigabitEthernet interface is disabled, the input erros increases rapidly. we havnt configured that interface and as said, it is disabled. an...
Hi all,i have a simple question which couldnt find any answer googling.access Switch (2960x) Distribution Switch (C9500)Gi1/049 Gi 1/0/50 (member of Po1) Twe1/0/10 Twe2/0/10 (member of Po10)Interface Twe2/0/1...
Hallo everyone,i just have a basid question, below is the show interface Te1/1/4 human-rea output of c9300 Switch,show int Te1/1/4 human-readableTenGigabitEthernet1/1/4 is up, line protocol is up (connected)Hardware is Ten Gigabit Ethernet, address i...
Hallo Everyone,i have encountered a very strange situation after updating C9500 Switch using ISSU from version 17.3.4 to 17.09.06. the problem is that the hosts of a privat vlan (used for OOB Management)is not reachable anymore. even though the the M...
Hi All,i have a little confussion and couldnt relate rd and rt values. i have read many articles and posts but still couldnt uderstand the relation.scenario:vrf definition CLIENTSrd 32052:2address-family ipv4 vrf CLIENTSroute-target export x:x route...
Thanks all, we found the problem and it was because of cabling error. onsite team mistakenly connected cable from another switch part of another port channel to the port which was being suspended. but magically, i don't see any syslog messages eighte...
yes correct, on 2960 side the portchannel number is 1 and on 9500 10, it should not be a problem correct ? because portchannel numbers are local to switch and we have couple thousands of access switches with same design.by the way, do you remember an...
yes i did, even i read line by line without filter, nothing is theredo you know any command which tells me the reason ? or do you if need to enable any specific logging under Physical interface or Port-channel beside "logging event trunk-status" and ...
