Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have a WLC 5508 running under 8.3.143.0 version.We found a problem trying to connect a device to a SSID.After debugging mac address this is what we get: (Cisco Controller) >config sessions timeout 0 (Cisco Controller) >debug client e4:42:a6:...
Hello,We have a WLC 5508 running under 8.3.143.0 version.We found a problem trying to connect a device to a SSID.After debugging mac address this is what we get: (Cisco Controller) >config sessions timeout 0 (Cisco Controller) >debug client e4:42:a6:...
Hi Team,
We found an issue with our Prime. It's running under 3.1 version.
We are monitoring all customers network with Prime and few days ago one of the members of a stack of WS-C3650-48TQ has an electric problem.
Cisco Prime didn't notified any...
Hello,
We changed the router that our ISP provide to us by a Cisco 867VAE-K9.
Our access line is a symmetric 300Mbps FTTH.
Now, using the Cisco 867VAE-K9 we can't reach more than 200Mbps.
I was reading the Data Sheet for this model but I couldn't fi...
Hi,I've a problem to apply a certificate to a WLC 5508.We generate the .pem but when we transfer it to the WLC we receive the next message: (Cisco Controller) >debug transfer tftp enable(Cisco Controller) >debug pm pki enable(Cisco Controller) >trans...
Again, thanks for your help.
This is the switch model and versions:
Switch Ports Model SW Version SW Image Mode------ ----- ----- ---------- ---------- ----* 1 52 WS-C3650-48PD 03.06.06E cat3k_caa-universalk9 INSTALL 2 52 WS-C3650-48PD 03.06.06E ca...
Hi Seb,
Thanks for your reply.
There were an electrical problem on customer networks and only affected to a member of the stack.
We don't have any SNMP trap configured only the customers comunity, that's all.
I thought that despite the stack ha...
Thanks for reply!
We are sure that we are getting the speed we are paying because when we connect the router provided by our ISP, it can reach 300Mbps. The problem is when we connect the Cisco router.
I'll take a look at this link to see if I find a...
