Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,I have this problem. I built out a LAN for a customer using private IP addressing. On the WAN side I'm using a pool of public IP Addresses to provide NAT. The LAN works for most Internet applications including voice but I have an issue with ...
Hi, I'm using catalyst 3750s and cisco acs 4.1 to authenticate clients but I need help. The docs tell how to configure basic web auth on ports but I need more details as I'm very new to this. For example, do I need an external webserver to serve the ...
I'm using a FWSM on a CAT 6509 and I need to configure static nat on a destination address. That is, if host A wants to speak to host B then host B adress is translated to host C. I need to do this to reslve an overlap issue.
I have a AS5400 with 384 modems and 16 T1 giving a line to modem ratio of 1-1. I have a problem when the utilisation reaches 100, that is all 384 modems in use. When a customer disconnects the modem port remains in an open/active state. The only way ...
I have a AS5400 with 16 channelised T1 on it. I have a local user on the RAS. 15 of the T1s belong to a certain hunt-group for general dialup access and the 16th T1 has a special number. I want the local user to be able to dialin via the special numb...
Hi,I ran across an interesting problem on a router here. I was seeing very high CPU load on it and a lot of input (overrun and ignored) errors on the Ethernet Interface. We swapped hardware, software, cleaned up configs, used MARS, Netflow etc lookin...
the vpn router is a nortel vpn router. nat traversal is enabled on it. but i discovered something today, i can use my cisco vpn. cisco vpn router is actually a 7401 router with vpn ios installed on it.
Well the thing is, I am having the same problem when trying to connect to my VPN and I know for a fact that NAT Traversal is enabled on my VPN router.If I use a 1:1 static NAT I can successfully connect. How about instead of using a pool of public ad...
Ok, but even after this when I do the web login, the switch is not sending any requests to the radius server. I even put a sniffer on the network and did nt capture any packets.Would you mind sharing a sample config with me?
