Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi... There is a way to configure an IPSEC VPN with a source-interface like in a router,? This is for a site to site VPN. I want to use a loopback interface. When I configured one VPN, the only option is the IP from the interface where the traffic is...
Hi everybody.
I got GETVPN infrastructure, with two keyservers and 32 group members.
Every time the rekey process takes place, all the groupmembers present high cpu usage and the Crypto ACL consumes all of my resources.
I am very lost, because is...
Hi Rajesh. Please told me the IP address of the interface VLAN3, a "show ip router pc_address" in router and "sh ip route 172.16.33.12" in the Core Switch.
Hi,
Doesnt seem to be the usual setup where the ASA directly would have 2 different interfaces connected to 2 different routers
You can use IP SLA to track a public address, if the connection get lost, erase the route from your routing table.
sla...
Try "icmp-echo" instead "icmp-jitter".
The icmp-jitter needs a responder on the other side. You can use icmp-jitter between two routers, one with ip sla operation, and the other one with the ip sla responder.
ip sla 1
icmp-echo 192.168.17.1 so...
