Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I have an issue on a client topology with two Nexus 5k. We are running a Dual-homed FEX topology with Config-sync on Nexus 5k only used for L2 purpose. We had no problem until we changed the mgmt0 interface IP address on both Nexus switches. ...
Hi Everyone,
I'd like to share with you an issue that I'm facing on ASR901 platform. I'm just trying to set up a simple QinQ configuration over a g.8032 Ethernet Ring but I have troubles with MSTP and I don't understand why...
Here is the configura...
Hi everyone,We are experiencing an issue on a migration of a Cat6k chassis to VSS. We have migrated without any issue the first chassis but the second chassis is stopping his boot sequence just after the RP has extracted the IOS image (going down to ...
Hi all,I'm trying to get working a fresh install with 802.1x in it. I have a serious issue with Windows XP SP3 not authenticating at all... I can see (with a Wireshark) EAPoL Start messages going out from the host, but nothing happens after. The swit...
Hi all,I'm a bit lost with an issue on ISDN interfaces...I'm using ISDN for satellite needs and I'm facing a strange issue on one vessel. Let me explain the case :From the vessel to the HQ ISDN concentrator : everything is OK (here is the debug isdn ...
Hi all,Is it possible to get more informations about this Bug? We had yesterday a client who experienced a similar issue with Prime Infrastructure on the network. Is it possible that the Campus Manager module would generate this logs in the new Prime...
Thanks Reza for this quick answer.I will try it as soon as possible.Thanks for your help, I confirm, this command is not scary but not in the good place if we really think about it. If you manage to get the chnage from Cisco about a no slot command, ...
Hi Reza,I don't understand how the "no module provision switch x" will remove only one slot among others. Don't you think you have to enter the module provision switch x and after clear the module with a no slot x...?Do you know if there is any impac...
Hi all,Thanks for your replies.You're quite right concerning Config Register (the good value is the one you mentioned), but the issue was not there...In fact, we finally managed to convert the chassis in VSS, but we had to modify the running-config c...
