Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
A customer has bought a ASA 5515-X with Firepower Services 6.0.0. I have added the license for the device (VMware with 2 Devices) but he hasnt licenses for the services (URL, etc)
When i enable the service policy into the ASA and send the traff...
Hi,
I have installed a GNS3 lab and i have configured the routers for gre tunnel over ipsec, as seen in the attached picture.
Attached you can see the configurations of the R3,R1,R7,R4
The problem is that with this setup the tunnels are up but i c...
Hi,I have a csc-ssm installed and i am facing a problem. The license has expired and since yesterday some sites works fine and some other doens't.Cisco saids that if the licenses expired you will continue having internet access but without filtering....
Hi to all,We have the following scenario:We have a single Cisco ASA 5520 with the following zones:1. Outside (connected to ISP1 with a leased line connection)2. VPN (connected to ISP2, with an adsl connection)3.InsideThe default route is to ISP1, in ...
Hi,I have a strange problem.I have an asa 5520 with a csc-ssm-20 module installed.I pass the traffic for the inside users (a Class B flat internal network) through the csc exempt some specific users, which i dont want to be filtered.Everything is ok,...
My friend gpauwen i would like to thank you for the corrections that you have made to the configs.
I copy your corrections and the lab works fine!
I think that the main problem was the below command:
In my config i had the 192.168.5.2 ip address and...
Hi,
The tunnels are up/up.
Because i have no other ideas about the problem, i have attached the whole GNS3 lab, in order someone of you can help me more.
I have made many changes but i can't see what going wrong!
If you have time take a look!
Hi again
I have implemented all these nice things that you have told me, and in the attached files you can see the configurations of R3 and R4.
Now, as you can see, i can ping the tunnel destination of both R3 and R4 (R3:1.1.1.1 and R4:2.2.2.2), but ...
Thanks for your answer.
As you can see on R3 and R4 i have default routes pointing to the other end, so i dont think that these extra routes will help.
