Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, folks:I am new to Cisco VoIP solution. I would like to set up a Cisco 7960 phone. When I provisioned the phone, I noticed that there is a parameter called "Admin VLAN ID". Since my phone is connected to an access port of a switch, I believe it sh...
Hi, folks:I found out yesterday that there is a new command introduced in 12.2 load. standby group# preempt delay sync delay-in-secMy question is, how we can interpret this sync delay value? Does it mean, the local HSRP instance will not become ACTIV...
Hi, folks:I enabled NBAR on a GigE port facing to the WAN side. When I displayed the protocol reported by the NBAR, it showed a large number of un-defined packets:R#show ip nbar protocol-discovery interface gigabitEthernet 7/2 unknown ...
Hi, folks:I enabled a QoS policy on a VLAN interface yesterday on Cat 6509 running Cisco IOS image. The QoS policy includes "match protocol" command. As a result, the NBAR is enabled automatically on the VLAN interface.I noticed that a log is generat...
Hi, guys:I have a quick question. Based on the BGP route selection criteria posted by Cisco, the route with higher local preference is preferred. The route type (EBGP or iBGP) comparison is way down on the list.So my question is, if an iBGP speaker o...
Hi, Ashok:Thank you very much again. You are correct. CQ has preemptive queue. I already forgot it. 8-)If I apply CQ tool on this interface (1p2q2t), even if CQ allows me to use up to 16 queues, I still only have 2 regular queues to play with? Am i c...
Hi, Ashok:Thank you very much for your reply. So does this mean, even if I used CQ tool, which supports 16 queues thereotically, I still can only treat the port as 3-queue system?Because CQ doesn't have the concept of priority queue. Does this mean i...
