Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ...
We have some sites connected through Cisco ASR1001-X routers. I've attached the schema and "show inventory" of two routers to show the modules and models.
We configured "pseudowire" Ethernet over MPLS to extend some VLANs. This configuration...
Hi ... your help in this case. I have a network with two principal sites and 70 branch office. The connection to branch office is through two providers WAN1 and WAN2.WAN1 connects branches using OSPF in MPLS L3 and the WAN2 connects branches using...
Hi ...I have a C200 M2 server with a RAId 5 array.One of the disk of array is in failure and we have the replace.I need the Official Cisco Procedure to replace the failure disk.Anyone can help me how to find the manual of procedure to replace the dis...
Hi ...Please your advise and help ...I have a cluster of PIX525 with 7.0(4), some days ago the Primary PIX failed and it was impossible to startup again.The failover worked and the PIX Secondary worked ... but this Secondary has a fail and every day ...
Hi ...I'm trying to configure a ACS 5.4 for Device Admin.I have Cisco devices on TACACS but I have some APs Canopy that use RADIUS for AAA.I configure Access Services (Network Access) in RADIUS with RADIUS-IETF: Service-Type: Administrative or Login ...
Thanks Lulian ...
I know the SPAs do "IP over E3/T3", but we need DS3 over IP.
The point is when we tried to configure circuit emulation, we are not sure about the compatibility of this model of card with this feature. The card we have is SPA-2XT3/...
Thanks Marvin ...Good idea about Cisco Security Manager for analyze the configuration, I know this is a horrible configuration and it's no easy to clean it.Guillo.
