Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Sep 1 20:13:11: %C4K_IOSINTF-5-INCORRECTSRCMAC: Source mac (78da.6e09.f3bf) in the packet matches the source mac of the router on interface Gi5/2Sep 1 20:13:15: %C4K_IOSINTF-5-INCORRECTSRCMAC: Source mac (78da.6e09.f3bf) in the packet matches the s...
Hi All,I have built VPN on Cisco 7200 router to remote site Juniper ISG 1000.Phase 1 is up but Packets are not decrypting.I tried to debug ipsec , but not able to see any error in logs.Below are some logs can some body help me (Peer IP hided due to s...
Hi All,I have 3945 router using the HWIC-4ESW module.I am not able to see the HSRP configuration commands under these interface.Does this module support HSRP ? If yes , do i need upgrade the IOS of router.Thanks & Regards
Hi All,We have observed WS-C4507R-E got rebooted while creating the L3 VLAN ( while No shut).Is there any known bug for below IOS ?cat4500-entservicesk9-mz.122-40.SG.bin, can somebody help ?
Hi All,Found some strange behaviour of VLAN on 4507 , below is the summury of incident.In sh run port showing to VOICE VLAN 305 , but port was sending broadcast on 303 VOICE VLAN.AVAYA IP phone was configured with VOICE VLAN 305 only.It was working f...
Hi,show interface | in GigabitEthernet|78da.6e09.f3bfTenGigabitEthernet3/1 is administratively down, line protocol is down (disabled) Hardware is Ten Gigabit Ethernet Port, address is 78da.6e09.f3bf (bia 78da.6e09.f3bf)TenGigabitEthernet3/2 is admi...
It is local to this switchshow mac address-table | in 78da.6e09.f3bf 10 78da.6e09.f3bf static ip,ipx,assigned,other Switch 20 78da.6e09.f3bf static ip,ipx,assigned,other Switch Po12 78da...
Tried as per above suggestion , but still above MAC is learning via Port-channel or port members of this port channel.I am not able to find the end user port from where this MAC is learning.Also this mac is showing as hardware address sh int po12 | ...
Hi Inayath,Thanks for reply.All the ports showing in logs are end user port , there is no cisco device in sh cdp ne , SH MAC ADDress-table INT GI5/2 Multicast Entries vlan mac address type ports---------+---------------+-------+---------...
