Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,Anyone used the following part for outdoor mesh AP power feed: 40-ft (12.2-m) power cord (AIR-CORD-R3P-40NA=) for light pole installations in the US and Canada.I wonder what happens when the lights turn off?Thank for you input in advance. Ma...
Hi Team,I installed Cisco vWLC for the first time. Everything works fine except my guest vlan doesnt get IP address from the designated dmz network. I was wondering if I am missing something. Currently Flexconnect it configured on the wlans with LOCA...
Hi all,Yesterday, I was asked a very interesting queistion. Can I configure HA over the WAN connection b/n our HQ and DR? Each location has a WLC 5508. My first answer was NO based on the HA (AP SSO) Deployment Guide; however, I wanted bring this to...
Good day all,I have a customer who wants to do a static mapping in order to prevent any downtime for one of his public web servers. Can someone give me a good example to follow? FYI, the edge device is:CISCO1941W-A/K9 (configured as a zone based fire...
Hi all,I just got off the phone with customer that has passed a security scan check from a third party vendor. One of the vulnerebilities mentioned in the report is as follows:I know that only the IPsec client VPN uses aggressive mode to negotiate Ph...
Here is the solution!First of all, if you configured Flexconnect in local mode then make sure to apply the appropriate native vlan, and vlan mapping in order to match vSwitch and the Physical switch VLAN mapping. Next, make sure to enable trunking on...
Hi Scott,Thank you for your quick reply! The vWLC is located in the Data Center. I haven't deployed anything to the branches yet. So I didn't find an option to enable central auth-central switching and I guess I will need to disable the Local option....
I solved the problem! Thank you for your help!Here is an example of what I've done:ip nat inside source static tcp 10.0.1.4 443 1.1.1.1 443 netmask 255.255.255.255 extendedip nat inside source static tcp 10.0.1.4 443 2.2.2.2 443 netmask 255.255.255.2...
Hi Rahul,Please follow the steps in the following link:http://www.cisco.com/en/US/products/ps6366/products_tech_note09186a0080a3443f.shtmlI hope this helps.Marty
