Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, since november 2023, when our cisco prime 3.10.4 trying to get the config via ssh from our 4510+R Switch, the privilege level 15 changed to 1 and the ssh connection fails. Bevor the config was archived correctily. This problem only occours wit...
Hi,after a upgrade from xe 3.11.07 to 3.11.09 we cannot open a ssh session to our 4510+R Switch. Before the upgrade everything works fine. The error message in the log is:%SSH-3-BAD_PACK_LEN: Bad packet lenghthWe zeroised the rsa key and generate i...
Hello, one of our 2802i ap stucks in init>> after reset to factory defaults. It don't connect to our 5520 master controller anymore.Any ideas?Best regards,Hubert this is the console output: *10/12/2021 08:58:12.5564] Failed to initialize Crypto.[*10...
Hello, I must change the subnetmask on the management interfaces of our controllers, because the IP range in the subnet reaches its limit. Our APs are configured with static IP adresses. Do they fall back to DHCP when I change the mask or must I chan...
Hello, we have a 1532E outdoor AP with the following error: "802.11a/n' interface of AP associated to controller is down. Reason: Radio reset due to (27) Radio interface has been shutdown". Radio reset code 27 table shows "--not used--" as reason. Th...
%SYS-5-PRIV_AUTH_PASS: Privilege level set to 1 by username on vty0 (IP Address)002808: Mar 15 22:00:12: %SYS-6-LOGOUT: User username has exited tty session 1(IP Address)
Verify credentials said everything is ok. If I do a ssh session to prime and from there a ssh session to the 4510 it already works but not from prime config job.
