Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
Not sure if in the right group here, but I've been upgrading old 2811 with ISR4331's, this one solution runs HSRP on the client facing side with matching static NAT entries, no problem till i upgraded both routers, currently had to roll ba...
Hi,
Been a long time since I've posted on here, but new to GETVPN, been asked to diabled fully without any down time, so looks like all GM have a open fail policy and no local ACLs.
what would you good people suggest as good way to allow traffic ...
Hi,Anyone else using these WAP561s?every few days I have to power cylce the box because it freezes, I have now opened up another of the same model but with older firmware to see if it happens on this one as well.ThanksKev
Hi all,Got my very first WAP561 Access Point, trying to get Capitve Portal to work and the local authentication page never comes up for my guest login, have followed the help steps, created instance, web locate, group and user, tied them all together...
Hi,I am in the Lab playing with VRF, got it to work when the switchport itself is a no switchport with IP address, however if I stick the Wan connecting interface into a vlan EIGRP wont create a Neighborship though I can ping it under that VRF.interf...
So managed to sort it via TAC case, even though the config hadnt changed and been the same for the last 12 years, the upgraded hardware and IOS forces the error.
Any incoming static NAT address that's also within the interfaces own subnet and runni...
Hi,
Sorry my question is any idea why I'm getting duplicate ip address errors messages once these routers are BOTH upgraded with the same configs?
sorry I missed out the duplicate IP address are static NATs, so router A has errors that 192.168.1....
Hi,
Currently my options are
1) Deny ip any any on KS gdoi ACL (wait a week to see if any fallout, then safety remove config on GMs)
2) Remove all GM peer IP addresses on KSs
3)on GMs remove VPN map command from interfaces as you suggested.
T...
Hi Richie,that bit will work, but only without enabling the captive portal and having the correct topologly in place. Cisco are saying the portal only works on the management vlan, but I dont see the sense in that at all, it seem draft!!I am trying t...
