Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,has anyone experience with the following scenario?A client connected to internet via DSL opens a tunnel to a production network where Siemens control system is used. On the client computer Simatic S7 and Simotion software is running. With this ...
Hello,I use a ASA 5510 running SW version 8.0.4 as a remote access IPSec gateway. The clients use Cisco VPN client. The ASA has one fixed outside IP and uses PAT for inside clients to connect to the Internet. One new demand is to passthrough IPSec tr...
Hello,recently I updated my LMS from 3.0.1 to 3.1 and downloaded the available patches also. Now I do have problems within CiscoView on devices of type Cat6k IOS. The device package which I use is of version 30.0 (seems to be the latest one). On the ...
Hello,recently my customer did a database recovery because DFM database was corrupted. After a successful recovery synchronization of the config archive fails. Most times there is a problem in getting the running config of the device. But sending the...
Hello,does anyone has experience in upgrading the 1113 SE from 4.0.1 to the current version (4.2)? Our customer does not have a recovery CD. I did not found such an image on CCO. In case of any problems how can the system be recovered? Exact version ...
Hello Joe,the customer did a recovery according to the manual (from online help). The topic is: restoring data on Windows. I just requested the logfile from the customer. Maybe that might be useful for further troubleshooting.
Hello,as suggested by Joe I did a re-imaging of the new box (option 1 Local Controller). Afterwards the old config could be imported without any problems. I'm currently importing old events.Markus
Hello,today I was running into the same problem. I tried to migrate an old MARS 20 (Gen 1) box running 4.3.6 to a new MARS 25 (Gen 2) box running 6.0.1. The new box was delivered with version 5.3.2 and I had to do the whole upgrade path to get versio...
Hello,I'm also searching for a solution similar to you. A customer of us wants to connect his remote site in a foreign country to his central site. On both sites there are 2 ISP connections. Fail-over is a must for the setup but load balancing would ...
