Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two switches Cisco 6500 one side have a supervisor 720 with CATOS version 8.6(5) and the other side have a supervisor 32 with IOS release 12.2(4)15a. the switch with the supervisor 720 have configured UDLD enabled and the supervisor 32 side h...
i have installed a CME with a client, and my problem is that sometimes an extention permanently have the state off-hook and it can't be used for anybody, the phone asociated with the extention have no sound and when a call arrives it present a busy t...
I have 2 WLC 4404 with capacity of 100 AP each one and i have 170 AP around the country (MX).all 170 ap's in this moment work in autonomous mode, i want to upgrade each one to LAP mode, i starting with 2 in one location trough the WAN but after i upg...
Hi Playne,I recently solve an issue like yours putting the command 'management-access inside' in the configure mode.the teory is that the ASA needs to know the websense from the inside interface with the command that propose Jennifer,i hope this reso...
IOS 12.4(15)XZ1, and the phone is an analog phone conected to an ATA.i don't remember the version of the ATA but i think it could be the problem, but do you know a procedure to fix the problem without reload the router?
ok, the ports in the range of the ACL:access-list 102 permit udp any any range 16384 37276 are used by the WLC to send the JOIN_REPLY paquet to the remote AP, the use of this ports in the ACL for voice was causing the issue,
i had a problem with a ACL in class-map that match with the UDP ports of WLC destination paquets,like this:access-list 102 permit udp any any range 16384 37276access-list 102 permit udp any any range 8100 8150access-list 102 permit udp any any range ...
