Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have implemented in my small network DMVPN and after that - per tunnel QoS as per:http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_dmvpn/configuration/15-mt/sec-conn-dmvpn-15-mt-book/sec-conn-dmvpn-per-tunnel-qos.html
It works lik...
Hello,
I have flexible netflow configured for ipv6 like this:
flow record ipv6-hor-ror-router-1 match ipv6 traffic-class match ipv6 protocol match ipv6 source address match ipv6 destination address match transport source-port match transport destinat...
Hello,I have virtual Wireless LAN controller and FlexConenct APs - 3602.WLC is located in central site, in which i have two AP in flexconenct mode (cannot use them in other mode due to virtual machine host cannot pass vlans) and remote (spoke_ site w...
Hello assetbank,
Which version you try to upgrade to?
What is the hardware model of the appliance (or paste here output of version command).
Can you also paste output fro mthe upgrade process via CLI?
Apparently found the problem, for example:
interface Tunnel6no ip flow monitor ipv6-mon inputno ip flow monitor ipv6-mon outputipv6 flow monitor ipv6-mon inputipv6 flow monitor ipv6-mon output
So, for ipv6 flow to work, command is ipv6 flow..., n...
Well, I did not have other to test with or be sure they experience the problem (have one that disconnects pretty quickly and never connects again, but do nto have physical access to reset it)Thus I set up today raspberry pi with wi-fi adapter, it doe...
yes, client disconnects at the very same moment I see this,yeas, it is macbook and I am not sure whether the problem started after upgrading to yosemite or it was there, but I did not notice it (as I am spending much more time in this wi-fi environme...
