About kirk

kirk · 11-24-2009

Hi I have a new Cisco 3845 and am at the ROMON console. I need to download the approapriate IOS however I cannot get a list of the hardware installed. How can I get this if there is no SHOW command in ROMMON? After I get past the hardware list I can ...

kirk · 10-31-2001

I am trying to configure snmp on my PIX 506 using the commands below without success. Help.Logged in as enable...Step 1 Identify the IP address of the SNMP management station with the snmp-server host command.Pixfirewall#snmp-server host 172.x.x.xWhe...

kirk · 11-25-2009

Hi Leolaohoo, thanks for the advice. That is exactly what I wanted to know. Can I format the new 256MB flash after I take the 64MB flash out? If so how do I do that when the IOS that is on the 64MB flash will be removed. Also, can I connect a USB tha...

kirk · 11-25-2009

Hi Glen,You were correct when you said the 3845 came with an IOS. It has 12.4(13r)T. I had removed the 64MB flash memory module from the router when I assembled it and replaced it with a new 256 MB flash module not thinking there was an IOS on the 64...

kirk · 11-01-2001

jcarvalho@ehealthdirect.com, thankyou for your help. That is exactly what I needed to do. Again thank you for your help.

Member Since	‎10-31-2001 11:25 AM
Date Last Visited	‎07-04-2018 12:05 AM
Posts	5

User Statistics

User Activity

Brand New 3845 - Need IOS

How do I configure my PIX 506 ver5.1(2) for SNMP

Re: Brand New 3845 - Need IOS

Re: Brand New 3845 - Need IOS

Re: How do I configure my PIX 506 ver5.1(2) for SNMP