Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI recently got two 4500X boxes I'm trying to get going in the lab. It seems that getting management working is biggest challenge. The preinstalled IOS XE was cat4500e-universalk9.SPA.03.04.02.SG.151-2.SG2.bin witch works great. No issues so far.I w...
HiI recently got our new 4500X delivered and I'm trying to wrap my head around how the Fa1 out of band management works in VSS mode compared to how the 2960 out of band management ports work and behave. The 2960's in stacked mode only have one of the...
HiI would like to understand what exactly happens when you turn on peer-switch within a vpc domain on a N7K vPC setup. Today we have only a few vlans rooted on the primary vPC switch. The secondary vPC does not have any spanning-tree priority for the...
HiAnyone ever found a way to make this work without using the global routing table as the "management vrf" ? I have the same routing issues as the OP describes. Same config. Same debug output. Tried to use the vlan interface as source interface as we...
So, in the last nights window I enabled peer-switch in the following order.Primaryconf tvpc domain 101peer-switchwrSecondaryconf tvpc domain 101peer-switchexitwrChecking logs I got the following line telling me to sync the spanning-tree config betwee...
subriyer,Thanks for that insight. Since the max throughput for the SSP10 is set to 4Gb/s it kind of sounds logical, yes. Would it make sense to only bundle 4 between each cluster member to each Nexus for CCL since it would hit the cap there on throug...
