About msdavis

msdavis · 07-25-2007

I am running a VPN over a pair of 1410's and experiencing less than stellar performance ~ about 2Mb/sec. The radios are operating at 54Mb/sec, the signal strength is -32 dBm, the signal to noise is 59dBm, the Ethernet side is running clean.The only e...

msdavis · 08-02-2007

Well - Sounds like that might be something to try - it couldn't hurt.Thank you for relaying the information.

msdavis · 08-02-2007

No - they are recent installs. But the code we are using is the 12.4.3 code, which is the latest and we just upgraded to the latest rev, just as a measure before opening a tac case.Did your customer back-rev the code and get the performance back? If ...

msdavis · 08-22-2002

The PIX is designed to not allow traffic entering an interface to exit that same interface. This is be design to stop any use in proxy type attacks. I don't believe that this is possible with the current PIX code. I think that the VPN concentrator so...

msdavis · 08-22-2002

I have been using it for some time from California to Germany and Italy with Polycom equipment and have had good results.The latency is there, but I think there is a an inherrant acceptance of turn-around time with Video Conferences. There is a sense...

msdavis · 04-30-2001

You can indeed have it dail your voice mail system -- Service Parameters - Call Manager - Voice mail. It is a string value that you insert the number to dial to access voice mail.

Member Since	‎04-30-2001 01:48 PM
Date Last Visited	‎05-10-2021 04:02 PM
Posts	6

User Statistics

User Activity

1410 Slow Performance

Re: 1410 Slow Performance

Re: 1410 Slow Performance

Re: vpn PIX -VPN 3XXX hub and spooke

Re: Videoconferencing: IP or ISDN?

Re: Messages button on 7940/60?