Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a static route defined on Catalyst 4500X switch that I am redistributing via a route-map. The route is received on layer 3 connected neighbors, but not on layer 2 (trunked connection) neighbors. Has anyone run into this?
I have an ASR that is connected to a switch. Even though there are no devices plugged into the switch, the asr's arp table shows there are. The arp entries are of devices there have been removed from the switch. I cannot get rid of these arp entri...
Hello,I have two routers that geographically seperated but have an indirect connection between them on the back end. Both of these routers connect to the same MPLS cloud. These routers are learning a default route (0.0.0.0/0) from the MPLS cloud. ...
I'm trying to understand what the best practice is in connecting multiple links to the Storage VDC. What is recommended, connecting multiple links to the same line card or splitting it up between two line cards? Also not clear if you have to licens...
Can anyone weigh in on this? I have the same question. What is the best practice, mix F2e ports with M1 ports in OTV VDC or keep M1 only ports in OTV VDC?Thanks
Thanks for the response. I ended up rebooting the router. That cleared the arp table. I did issue the commands in this post, but did not remove the entries. Will see what happens again.
Thanks Peter. I think what was throwing me is the router with equal number of hops to both ASBR is in the same vlan as one of the ASBR. The middle router has 2 hops on GigE links to one ASBR and 2 hops on TenGigE links to the other ASBR. I believ...
