09-09-2013 08:11 AM - edited 03-07-2019 03:22 PM
I have an ASR that is connected to a switch. Even though there are no devices plugged into the switch, the asr's arp table shows there are. The arp entries are of devices there have been removed from the switch. I cannot get rid of these arp entries on the asr. Am i missing something?
09-09-2013 08:26 AM
Did you run the following command:
"clear arp-cache interface" (followed by the interface number)
or
"clear arp-cache" ( followed by the IP Address)
09-09-2013 01:48 PM
Hello Jignesh,
Please, share the following outputs from the box in order to get a view of the stale entires.
# show ip arp
or
# show ip arp vrf
Thank you
--
Best regards,
Dmitry Skotnikov
09-10-2013 06:19 AM
Thanks for the response. I ended up rebooting the router. That cleared the arp table. I did issue the commands in this post, but did not remove the entries. Will see what happens again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: