Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I need to configure 2 ISR4431 in High Availability and I'm having a hard time (never done it before).I keep getting this in both devices: RTDC1-01#sh reduRedundant System Information :------------------------------Available system uptime = 2 ...
Hi guys,
I have a Cisco 3560E directly connected to 192.168.5.0/24, and its only routing configuration is a default route to 192.168.30.202
SW1DC1#sh ip int briefInterface IP-Address OK? Method Status ProtocolVlan1 unassigned YES NVRAM administrativ...
Hi guys,
I have this weird OSPF behavior and I don't get it...
I'm running version 9.1(4) on ASA5512, this is the output for some of the routes:
FW1DC1# sh verCisco Adaptive Security Appliance Software Version 9.1(4)FW1DC1# sh route | inc 192.168.30...
Hi,
I have an ASA5540 perfectly running on ASA 9.1(4) and want to set up HA with another 5540.
When I use the ASDM High Availability and Scalability Wizard, I provide the new peer IP address and right away get this error: "ASDM is temporarily unable ...
Hi guys,I tried to upgrade a 5540 ASA from 8.2.5 to 8.3.1. When I did I got a huge amount of errors in NATs as per the unidirectional feature...Is there an automatic way to check my current configuration to fix all the misconfigurations? This company...
Hi Philip,
I would need to do the upgrade and downgrade again to get the logs but I haven't seen anything in particular.
But if it was a NAT issue, wouldn't it be happening on the current version as well?
Thank you!
I had a weak encryption!!
ciscoasa# sh run all sslssl server-version anyssl client-version anyssl encryption des-sha1
Resolution:
Enter the command: ssl encryption rc4-sha1 aes128-sha1 aes256-sha1 3des-sha1 in config mode.
That ASDM troubleshooti...
