Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi since some days we observe high cpu for the "ARP Snoop" process. This is on 6513-E coreswitches running VSS. I can not find information about tshooting this process. If anyone has a clue, thanks in advance!
Hi
we ran into a very weird issue
Setup: two 6513-E core switches running VSS, both have two power supplies
We ve had some power issues regarding one power supply. So had it replaced but still seeing some issues
At a certain point all kind of...
Hi
anyone seen this error? Not able to find info about it.
%EC-SW2-3-INVALID_CHANNEL_GROUP The channel group number 853 is invalid. The valid range is 0-512.
This is a channel to which a wism2 blade is connected. As the channel was created by the s...
Hiwe re running VSS with 2 6513-E switches. (Version 15.1(2)SY3) We also run ospf. I can not seem to find answers in the documentation for the follwoing questions: I want to enable nsf under ospf during production hours. Q1: when i configure nsf, wi...
It turned out that an old 3750X stack was acting strange and whatever i tried, all traffic from the stack was punted to the 6513 cpu- so i shut down all access ports on the stack > still same behaviour, high cpu on the core- then i shut down a member...
Hi
looking at a 3850 here with a 750 watts power supply, i think a 3850 switch allocates about 330 watts for internal operation/ booting.
The remaining (420 here ) watts is available for POE
With a 1100 watt power supply there will be around 770...
