Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm building a backup wireless bridge. It's going to be trunk link.How would I access management interfaces of the radios ? For now it's going to be L2 between 9200s, later another bridge L3 between 9300s.Tx
Hi, yeah, this is between switching or routing problem. Got two buildings connected with a very old fiber. We got a wireless bridge for failover redundancy. Basically availability of the link is critical and not the performance. Buildings very close ...
I had basic configuration done with a lot of help from this discussion.https://community.cisco.com/t5/switching/nexus-93180-vpc-and-vmware-recommendations/td-p/4850262I'm installing new pair of vPC 93180s and new VMWare hosts based on Epyc. Can't wai...
Probably should've bought different gear but got two 93180s in vPC config.3 VMWare hosts. 3 Vswitches on them. Each with 3 dual 25gbps NICs. Plus some 1gbps.Plan to use 2 ports from each host per vswitch connected to each Nexus for redundancy. Manage...
Hey, I've seen minimal cost difference between the 2802e with or without internal antenna. For flexibility is it possible to disable internal when external antenna is plugged in, or perhaps it's automatic ?Regards
