About CSCO12065472

CSCO12065472 · 05-28-2019

Hi All, I've been studying bgp dmzlink-bw. Looking at the documentation (link1, link2 for example) it all appears to say "neighbor dmzlink-bw" sends the bandwith in an extended community. However, I can enable unequal cost load balancing on one node,...

CSCO12065472 · 06-26-2013

I would like to forward a range of ports. To test I have setup a Static NAT with a route-map on various devices. However, every time I set it up all ports are forwarded; the route-map never gets consulted. Any advice on how to achieve this would be g...

CSCO12065472 · 06-02-2019

Giuseppe, that's great thanks. You answered my question. thank you for taking the time to answer

CSCO12065472 · 06-01-2019

Hi Guyseppe, Thanks for getting back to me. BGP multipath allows multipule routes to be installed into routing table. however, only when "neighbor x.x.x.x dmzlink-bw" is enabled on r4's neighbors is the interface bandwidth taken into account and the ...

CSCO12065472 · 08-02-2013

Since postingI have found a workaround. I have given the outside interface a secondary IP address and forwarded all traffic from there. In the real example I have an ACL on the outside interface to block the other ports.This is the final config:R2#sh...

Member Since	‎06-26-2013 05:08 AM
Date Last Visited	‎06-19-2019 11:53 AM
Posts	5

User Statistics

User Activity

bgp dmzlink-bw - send-community

NAT port range

Re: bgp dmzlink-bw - send-community

Re: bgp dmzlink-bw - send-community

Re: NAT port range