Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
i have a switch WS-C3750-24TS with release 12.2(20)SE3.
I would like to create a span port and to be able to mirror only the vlan interested.
I added these two commands to configuration:
monitor session 1 source vlan 1 , 200monitor sessio...
Hello everyone,
i have a question about NAT (8.4+) on a vpn l2l. i am in a situation where my network overlaps with that remote site.
I wish that when a host on my lan (192.168.31.114) needs to reach a remote host (192.168.247.1) on vpn tunnel is n...
Hi all,i have a strange error on my ASA5515-X and I can not understand what can be.I natted server-mail with services https:object network Owa_10.0.1.4 host 10.0.1.4object network Owa_10.0.1.4 nat (INSIDE,OUTSIDE) static interface service tcp http...
Hi all,can i nat two internal address with same services on one public interface address?I have an ASA 5515-X and i want to nat two services, tcp\80, on same ip public interface address:object network Owa-Interno host 10.0.1.4object network Sito-Inte...
Hi all,when receive a fax from a number of a customer my cme cut same digits.For example when receive fax from 271090935 to 331755511, the CME cut two final digits 11 and route a call to internal 01.This strange event occurs only on some numbers not ...
Hi Mark,
I have the same problem that the user had.
When configure span on destination port i have only this option:
Switch(config)#$sion 1 destination interface Fa1/0/24 encapsulation ? replicate interface replicates source encapsulation
the ...
Hi Mark,
i need to span only vlan defined on switch (in this case tag 1 and tag 200), so i defined only trunk destination port no other source port defined as trunk. Makes sense?
Thanks,
Marco
Hi Meheretab,
i tried to configure destination port as trunk but no avail:
interface FastEthernet1/0/24 switchport trunk encapsulation dot1q switchport mode trunk
Any ideas?
Thanks
Marco
I used packet-tracer command to verify that NAT rule matches:
ASA-D01# packet-tracer input LAN tcp 192.168.32.114 http 192.168.247.1 httpResult:input-interface: LANinput-status: upinput-line-status: upAction: dropDrop-reason: (no-route) No route to h...
