Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I was wondering if someone could answer the following question for me:I'm seeing SVI interfaces hit 160% utilisation on some of our 6509 switches. As these switches are in a VSS setup, is the utilisation effectively divided by the two VSS switc...
Hello,Having attended various road shows I hear that modular IOS is being phased out by Cisco. My question is therefore:What is the procedure for replacing my current IOS s72033-adventerprisek9-vz.122-33.SXI3.bin to the equivalent Native version. Are...
Is there a way of ascertaining whether my 5510's have 1 memory slot or 4 memory slots without having to open the chassis?I need to order the appropriate memory upgradfe kits.Thanks.
Hello,I recently had a situation whereby someone plugged 2 patch cables from the same stack into the 2 ports of a 7911 phone, thus bringing down the stack.Ports affected were Fa0/11 anf Fa0/13. Both went error dsiabled (as expected), but when one of ...
Hello,I'm trying to track down the physical switch that is acting as the Root Bridge for VLAN 2. From the output below I have found that 0221.5a6b.XXXX is the root bridge for VLAN 2. But this is a Learned/propagated address. So far I have looked at 1...
Thanks for this.However, how do I refer this question to manufacturing? my customer has many of these devices located in remote COLO sites where physical access is not easy and would have to be done out of hours.
Hello,Problem solved. Root bridge traced to an XP Workstation!!!. Made the Core swicthes the Root bridges of various VLANs. This fixed the HSRP Failover situation that was being experienced.
