Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We are running several 4500-X VSS setups and we would like to upgrade them from 3.4.x to 3.6.x. Cisco states that ISSU is not supported due to incompatible software changes. So I asked TAC if it was possible to do an upgrade while keeping only la...
Hi, Do the new Cisco ISR 4400 series routers support SSLVPN?According to the feature navigator it does, but according to the 4451-X Q&A document it doesn't. Does this mean that I can or cannon use the AnyConnect client? Thanks. Regards, Armand
Hi,I'm facing the following issue:Cisco 891 <---1Gb,fulld,ethern---> Cable modem <---10 mbps upload ---> ISPI have a policymap with a shaper and a child policy map configured like this on the wan interface of the 891 (Giga0): Policy Map QOS_WANOUT_P...
Hi,I would like to know if the RV320 allows PPTP Remote Access with the use of a radius server. The important part here is that the radius server is located on the Internet!The reason I ask this is because I have another router here (Draytek). And th...
Hi,My ZBF configuration on a Cisco 3825 is sometimes blocking websites, but not always. Lets say users browse to Linkedin.com, they click around on the website, accessing several pages and then suddenly they get the IE error saying that the website i...
Thanks for your reply!
What I'm still worried about a bit is what happens to the LACP / MEC during the switchover from the active 3.4 to the standby cold 3.6. I assume that the attached servers need to renegotiate the LACP protocol which can cause a ...