Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Will anyone be able to have a look at it for meversion - flash:c1841-advipservicesk9-mz.124-25f.binconfigurations:route-map REDIST-PRI-LB-TO-5413 permit 10 match ip address prefix-list LOCAL-CPE-LO0 set community 5413:2036!route-map REDIST-PR...
Hi there,I have a port on 7600 connecting via Single Mode Fibre to my service provider. Service provider has 1000-Full with auto-negotiate. I am seeing following output on my 7600sh int g3/0/7 | i duplex Full-duplex, 100Mb/s, media type is LXIf I do...
Hi All,Is it possible to use glbp to load balance when I have one router connected to two upstream routers and these routers are configured with GLBP. As far as I know there got to be mulitple hosts on the segment for GLBP to do any kind of load bala...
Hello,I have got this lab setup where ospf is learning two routes via two different processes. But it is prefering the route with higher metric. can someone please explain why ospf is taking higher cost route.My ospf database and routing table is as ...
HelloWithin an area ospf database need to be same for all routers so you can't do filtering in or out, even when you apply distribute list it only filters routes to go into routing table and routes still exist in database.What you can do here is assi...
