Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have implemented WAAS in an enterprise network. At HQ, we have 2 WAEs managed by a Central Manager and all branches are running WAE modules on 2800 series routers. All branch WAEs are registered on Central Manager at HQ. All is working well...
Hello there,I am running CUCM 9.0 with cisco voice gateway. All internal extensions are able to call PSTN and vise verse. The issue happens when a call is dialed from PSTN that is forwarded to Call Center queue. The phone rings but no audio is comin...
Hello there,I am trying to configure WPA2 802.1x authentication on my WLC that should use ISE as radius server which is set to authenticate AD users.The issue is that when I try to connect the SSID, it does not forward the authentication request to I...
Hi there,As subject explains all, I want to use ISE Guest Portal for my domain users. I have tried many different ways to authenticate users and finally I came to the conclusion that ISE CWA works pretty well and is very stable. WLC Webauth sucks...
Hi there,I am stuck in NTP, deployed WLC CWA using ISE that is integrated with AD. I tried using AD as NTP source but no luck(universal fact that Cisco uses NTP where as Microsoft uses SNTP).The issue is, if time is not synced between WLC, ISE and AD...
Thanks Finn for your reply. I have understood that DR CM should be configured as Standby. What about IP addressing? Normally, Branch WAEs are registered on Primary CM that has 2 DC WAEs. When DR CM is activated manually, it has saperate 2 DR DC WAEs...
Guys, I tried to route incoming call to another CUCM whivh is running on another site and that has a route pattern to my existing CUCM Queue extension. That worked absolutely fine. I can hear the sound without any issue.I will tell you the call flo...
