Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After provisioning the AIR-AP1832I-E-K9C we can no longer connect to the access point management IP (not pingable) and the AP does not broadcast SSID. We cannot also ping the management IP from the AP command lineany idea what could be the problem?Th...
Dear Support,We have the following scenario:1. A VPN site to site on ASA between three branches: Headoffice, Hamra branch and Dora branch2. All branches are connected through Two WAN connections: PESCO as a primary connection and DSL as a...
Kindly note that I have the following scenario and I need to configure a bridge group on the two routers:Head Office: LAN: 192.168.5.0 WAN: 10.10.10.1Branch: LAN : 192.168.7.0 WAN: 10.10.10.2Noting that I want to add a DHCP serve...
Hi,Kindly note that we have five routers 2811 which are distributed in all the branches and connected to head office router 2811 through a tunnel VPN; in other words, every branch connects to head office as well as to all other branches. Besides, we ...
Dear All,Kindly note that I need to access to the CSAT through my username.Unfortunately, when I login to the PAL I faced for the below error:Error You have not been granted access to the PAL tool. You may request access either on-line or by contact...
Hello, The Access point is currently connected to an unmanaged cisco switch SG200-26P to power it and connect my laptop in order to access the AP management IP. My problem for now cannot ping the management IP nor see the SSID (Cisco Controller) >sh...
My Aim is to configure the access point as stand alone without joining a WLC and at the sane time allow it to act as a controller for few other AIR-AP1832I-E-K9 access points. What I meant by provisioning is: - I connected wirelessly to CiscoAirProvi...
Please note that i have the subnet 192.168.5.0 in head office and i need to put a server in the branch site with the same IP of the subnet of Head Office, so how can i do a routing on the same subnet?
