Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a question.
I build VTI's to 2 separate destinations (2 tunnel interfaces) that I would logically like to have as my outside Zone.
Added to this a standard Inside and a DMZ.
What happens to the "Sessions" noted in the firewall if a session...
Hi,
My provider is going IPV6 only - but I would still like to use IPV4 in my LAN.
The IPV6 prefix changes every 24 hours from my ISP.
So my question is.....
Can an ISR900 do IPV4-to-6 and VPN(IPSec/SSL) and Firewalling (ZBF or similar) at the same...
Hi,
I have 4 FTD's and on 2 of them snort is getting the CPU load to 60%+ on the other 2 the CPU including Snort ist less than 5% (this was the aim of the new devices) All devices have the same basic configuration but of course a different rulebase.
...
Hi All !
On my ASR 1001 - X I done a simple Traceroute and got this as a result
HostnameHere#traceroute 46.182.249.38
Type escape sequence to abort.
Tracing the route to 46.182.249.38
VRF info: (vrf in name/id, vrf out name/id)
1 80.81.194.140 [A...
Hi All
is it possible to get the device (a SG220 Switch) to send its Hostname instead of IP Address in a syslog message ? They are performing very well in a mainly De!! environment at this point in time and have still a few little things where the o...
