Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
As Nexus 7K platform doesn't support multihop BFD so i have to use faster the BGP hello and hold timers. When i try to configure BGP timers to "timers 2 6" (hold time = 6), i get a warning message as below
"% ISSU will be affected if hold ti...
Dear all,
I have few questions related to hrsp, vpc and mtu. I will really appreciate if you answer them.
Since both nexus switches forward the traffic regardless who is HSRP active. In such case do we need to laverage BFD for HSRP for faster converg...
Hi All,
Could you please tell me what are the disadvantage of running routing protocols e.g. iBGP between SVIs of two chassis over vPC peer-link? I heard cisco recommend to use a separate link for layer-3.
Thanks in advance.
Regards
YH
Hello Everyone,
A quick question regarding line cards distribution in a 7710 chassis. If i have two line cards per chassis. From high availibility point of view, Is there any pros and cons of installing both cards next to each other e.g. slot #1 and...
Hi Guys,Sorry for basic question. Can anyone please tell me show command to see all routes in all vrfs or in specific VRF where a specific RT is set. I think command "sh bgp vpnv4 unicast all extcommunity-list" can serve the purpose but then i will h...
Hi Reza,
The layer 3 link is supported but i curious to know why should i have a separate layer-3 link, what is the disadvantage of using peer-link for layer-3?
vPC peer-link is generally bundle with multiple physical link so should be consider more ...
Aninda,Thanks for simulating and the explaination. I also read more and reached to same conclusion. I didn't get the last part, the important note, can you please explain and also if you could give me source of this info."It is important to note t...
I am afraid you didn't understand the question. dampening can be done using route-map but the question was can we apply dampening on routes that are being redistributed from ospf into bgp on same router instead of learning them from ebgp neighbor.Y.
