Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Please use this Automatic Zone Set Distribution To enable the switch to distribute the local zone set to all other switches in the VSAN when a zone set is activated, use the zone set distribute full vsan 804 command: ca-9506# conf t
Enter ...
Hello Damon,Only B200 M3 server support TPM Module B200 M2 server doesnot support TPM moudle .Here are the steps for enabling TPM moudle in B200M3 serverStep 1 Enable Quiet Mode in the BIOS policy of the server’s Service Profile.Step 2 Establish a di...
Hello PeruPlease go though below link that will help you get the complete details of Data Center courses providing by cisco http://www.cisco.com/web/learning/certifications/associate/ccna_datacenter/comparison_chart.html
Hello Hardik,NAT: The Cisco Nexus 3548 supports NAT in hardware, with no impact on latency. Three types of NAT are supported: – Static Network Address Translation (SNAT) provides the option to configure static mapping between local and global IP addr...
