Hello,Please use this Automatic Zone Set Distribution To enable the switch to distribute the local zone set to all other switches in the VSAN when a zone set is activated, use the zone set distribute full vsan 804 command: ca-9506# conf t Enter ...

Hello Damon,Only B200 M3 server support TPM Module B200 M2 server doesnot support TPM moudle .Here are the steps for enabling TPM moudle in B200M3 serverStep 1 Enable Quiet Mode in the BIOS policy of the server’s Service Profile.Step 2 Establish a di...

Hello PeruPlease go though below link that will help you get the complete details of Data Center courses providing by cisco http://www.cisco.com/web/learning/certifications/associate/ccna_datacenter/comparison_chart.html

Hello Jose,The below link may help you to connect your FI with MDShttp://www.virtualdatacenter.me/2012/06/fibre-channel-trunking-and-port.html

Hello Hardik,NAT: The Cisco Nexus 3548 supports NAT in hardware, with no impact on latency. Three types of NAT are supported: – Static Network Address Translation (SNAT) provides the option to configure static mapping between local and global IP addr...