Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Introduction
This document describes how to configure a site-to-site (LAN-to-LAN) IPSec IKE Version 1 (IKEv1) tunnels using Virtual Tunnel Interface (VTI) between two Cisco ASA. ASA VPN module was enhanced with this logical interface in version 9.7(1...
Here you can find all configuration steps:https://supportforums.cisco.com/document/13259276/configure-failover-site-site-ipsec-vti-tunnels-between-two-asa-971-using-cli
Introduction
This document describes how to configure a site-to-site (LAN-to-LAN) IPSec IKE Version 1 (IKEv1) tunnels using Virtual Tunnel Interface (VTI) between two Cisco ASA. ASA VPN module was enhanced with this logical interface in version 9.7(1...
Hello,
i have an ASA5516X [9.5(2)10] and i'm trying to make an IPSec vpn with an Juniper device.
The topology is like this:
172.16.32.0<--->Router<-->192.168.1.0<--->ASA<-----Internet---->Juniper<---->192.168.123.0
One problem is that only ipsec tun...
Unfortunately OSPF/EIGRP is not supported at this time but you can use BGP which is supported.
I recommend you to look on this document: http://www.cisco.com/c/en/us/td/docs/security/asa/roadmap/asa_new_features.html regarding new features introduced...
Afther ipsec problem with Juniper SRX was solved the strange message still pops-up:
IPSEC ERROR: Failed to send the message to IKEIPSEC ERROR: Failed to send the message to IKEIPSEC ERROR: Failed to send the message to IKEIPSEC ERROR: Failed to se...
Is just one ike peer and two subnets behind ASA (two SA are needed). I allready found that the problem resides in SRX configuration, and the soulution can be found here:
https://kb.juniper.net/InfoCenter/index?page=content&id=KB20543&actp=search
Rem...
