Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I have several pair of 6513E with dual SUP2T modules and a handful of WS-X6908-10G.The 6908-10G are full of X2-10GB-SR modules connected to various 10G Nics by Intel & Chelsio.All of these ports appear to be stuck operating at 1G instead o...
Hello,
We are experiencing a lot of BAD_ADDRESSES in our DHCP scopes where 802.1x is enabled. The problem seems to stem from IPDT or Device Tracking depending on the version of IOS you have. This is not a unique issue to me.
https://supportforums.c...
I just configured one of my EEM applets on an ISR 4321 with a NIM-ES2-8-P. The applet should trigger on event mat mac-address but its not running at all. Is this a bug in the IOS or something to do with event mat mac-address on an ISR? TAC said tr...
So I am having an odd thing happen on WS-C3560V2-24PS-S series switches with EEM or just using the HTTP client by typing "more" followed by a URL.In some cases the last few characters of the URL are trunkated by the HTTP client.So "/plugins/identify/...
So is there any way to use HTTP GET params inside EEM? All I have gotten to work is use a CLI command "more http://<url>/$var1/$var2" action 2.01 cli command "more $identityserver/$_mat_mac_address"
They are on 15.5(1)SY3.The ports themselves say 10G but I am only getting about 700Mbps through the port. Its severally underperforming except there are no interface errors/collisions ect that indicate there is a problem.The switch fabric utilizatio...
Its a problem with the IOS. If your switch can be upgraded to a fixed one then just upgrade the IOS. Our switch did not support a new enough/fixed IOS so we had to replace all our switches with ones that had a newer IOS.
This seemed to only be a problem at sites with multiple 3750 stacks. If you can put all your access switches into a single stack then the issue seemed to go away.
Depending on what 3750 series you have you might be able to upgrade the IOS to a ver...
Hello,
I upgraded to 16.6.4 and the high CPU issue went away.
show proc cpu sorted | ex 0.00
CPU utilization for five seconds: 11%/3%; one minute: 50%; five minutes: 41%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process
468 ...
I did eventually get TAC to acknowledge that its a bug and that it should would. I was given a bug ID CSCvi93967 and looks to be fixed in 16.6.4 now.
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvi93967
