Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We will setup a iwan test enviroment with a apic-em (1.5).What is the requirement for a test hub site?Is it possible to create a hub site with isr4321?From the releasenotes i understand that just branch site is supported for this hardware.Is this a r...
Hello,we have a fax-machine connected directly to a bri port on a cisco3825 gw.To the pstn we have a e1 pri.pstn <--E1-- cisco3825 <--BRI-- FAXSometimes when we send a fax out to the pstn the receiver just gets a blank page but we see a sending succe...
Hi,we have a cisco 3825 with cme 7.0.On the router is a e1 and some fxs ports installed. Now we have some trouble with a fax.Networkclock is fine, no slips!card type e1 0 0network-clock-participate wic 0 network-clock-select 1 E1 0/0/0voice service v...
I cant realise more than two simultaneous internet dialin.I have a cisco 2821 and three dsl lines.There are three ethernet interfaces and three dialer interfaces configured. Every dialer works fine but I cant connect more than two dialer at a time.It...
Why change a port under normal conditions the status?Aug 25 08:58:11: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/43, changed state to downAug 25 08:58:12: %LINK-3-UPDOWN: Interface FastEthernet0/43, changed state to upAug 25 08:58:...
Is there anyone with a working solution for that?
I also need a routing protocol (ospf or eigrp) between a asa cluster and a nexus 7k peer (sup1).
Some designs I tryed are not realy full functional. There are many issues with the L3 peering. Special...
Hi Yama,do you know (or everybody else) it is possible to send blank pages with "ECM" enable?For us it is the worst case to get a "sending complete" and the other site gets a blank site because we ues faxes it for ordering.Does someone have a pots to...
Hi,thank you for your replay.I worked an this with the tac.It seems that we have a fax that dosent work 100 percent with the cisco fxs ports.I try it now with a internal bri port for the fax and take a TA to connect the fax.Sebastian
