Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a vPC cluster of two Nexus 7009 that needs to be connected with a VSS cluster of two Catalyst 6509s. The VSS has been working fine for a while and the vPC cluster is new equipment.Attached there is a detailed diagram of the connections; the V...
Hello everybody, Has anyone used the new USB cables that comes with new 2960s and new 3750s switches?I downloaded the driver for it seems to be only for XP/Vista because I installed it on my Win7 x64 and no success.Regards,DL.
Hello,I'm trying to get a NAC Guest server associated with an LDAP Server.I was able to get the NAC Manager working with the same parameters, but the Guest isn't working tough.My question is...where can I find useful logs about LDAP authentication wi...
Hi there,I had once de-attached the flash from Cisco 1841 by my mistake when it was being booted. Then, I booted it up again but it stopped reading hardware info, as follows:=============System Bootstrap, Version 12.3(8r)T9, RELEASE SOFTWARE (fc1)Tec...
Hi, Today 27.02.2020 I´ve found out the same problem and according to the compatibility matrix we need GLC-SX-MMD because the GLC-SX-MM is not compatible with several C93180 models.I´ve also found this external blog post talking about the difference...
Hi,
Actually I have worked over a similar scenario last weekend and as a matter of fact I can tell you the command does the job, you can establish the routing neighborship with the two Nexus running VPC.
In my case I´m using OSPF and before using t...
I'm having the same issue with a Nexus 7009, from 6.1(1) to 6.2(8)b with dual supervisors.Secondary Nexus went fine and then the primary gave me the same crash and was not possible to upgrade it.
Hello, Good to see you are talking about this; I'm wondering how and what I need to open the ScanSafe account in order to configure the policies. I have found the info to configure the ASA, and to configure and modify the content filtering policies o...
Thanks for the reply Dazhi; actually we did enable that after some attempts but at the beginnning it was not configured.I saw that in a config guide, but I'm not really sure what is the effect of that command.I'm attaching a debug from the N7K that w...
