Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco ASA 5510 IPS Firewall with ASA-SSM-10 Module. I am trying to do a manual update of the signature file and get the following error:Error: execUpgradeSoftware : couldn't connect to host I have confirmed that I can ping the ftp server successful...
Have the following configuration:Cisco 2921 Router with SRE-710 running CME 9.5No calls are working when using the MOH file that we had been using on a 2821 with CME 8.6 with no problems Have following commands in placevoice-port 0/0/0:23 local-alert...
We have around 50 phones on our network and are having an interesting issue. There are two users on the network that are both using CP-7962 phones and when they call everyone inside and outside they have no problems except when calling each other. ...
I have hooked up to the Cisco 2821 router a T1 on Serial and Cable Modem to GigEth0/1 and I want to split outbound traffic so that all regular users will use G0/1 interface for web traffic and the rest of the traffic stays with the T1. I am having a...
The solution was that the G722-64 codec needed to be added to the dsp farm. Make sure you shutdown the dspfarm first to add the codec. Thank you again for all your help.
The solution was that the G722-64 codec needed to be added to the dsp farm. Make sure you shutdown the dspfarm first to add the codec. Thank you again for all your help.
So I have gotten internal moh calls working using an moh-group. I still do not have pstn calls working and just get tone on-hold for the pstn calls. When on hold I do not get any logs from ccm-manager and current active multicast sessions are 0.
So I have gotten internal moh calls working using an moh-group. I still do not have pstn calls working and just get tone on-hold for the pstn calls. When on hold I do not get any logs from ccm-manager and current active multicast sessions are 0.
