Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI ALL
It is about following topology, the backbone area cut the area 1 in to two parts. now the plan is not to use virtual links to connect area 1. will it has any route problem? or any kind of unknow problem? the following are some captures. f...
Hi
I have question about the port-channel or call ether-channel LACP question. As i know, we can change the load balance behavior by change the st-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac OR each member port priority. the questio...
HI all
I have a nat problem on ASA. the structure is simple. nat inside source device to outside interface IP ( nat (inside, outside) source dynamic obj_192.166.168.9 interface) the reason use dynamic nat is because their is other devices need to...
Hi Every onei am not so familiar with ASA and have a question regarding to establish IPsec VPN between ASA and net-screen. I have configure an IPsec VPN over ASA as follow, do not have any interest flow and do not have any configuration over peer si...
i have internet IPsec connection between Cisco route and juniper net-screen SSG the tunnel is up and working.but the ping is not getting thought.
the cisco side configuration
#sho running-configBuilding configuration...Current configuration : 3588 by...
I have go the some type problems . Say R1 —R2-R3. R1 use RID10.10.0.1 and it got svu under this /24 subnet . R2 set RID 10.10.0.2 but do not have interface for this subnet. And R3 set RID 10.20.0.1 have interface under this subnet. The result will ...
here i fund the result.
the RFC
RFC 2328 OSPF Version 2 April 1998
of the graph connects to a network, or is itself a point-to-
point network. In either case, the edge is colored with the
...
